DTG Kiosk Fitting the Gap Sensor

Dean Armando

Click here to download the procedure for fitting the Gap Sensor

DTG Kiosk Preparing for an Extended Shutdown

customer

Transporting or Storing Your Printer It is extremely important you observe the following before transporting or an extended shutdown of your DTG Kiosk. Preparing the Printer for Transportation If the printer is to be transported over a long distance, and/or by a common carrier (where you cannot control the "care"...

DTG Kiosk Installing the WIMS Ancillary Board

customer

To learn how to install WIMS to Kiosk, click here.  KIOSK PARTS HM1 PARTS INK  

Diagnosing a Clog in the Kiosk II

customer

What I normally do is to try to isolate the issue from several possibilities to one. The only way to do that is to swap dampers. Follow these instructions to see if it is the damper or the print-head. Perform a nozzle check, and note the bad nozzle check and...

Download the Kiosk II Operation Manual

customer

Download the Kiosk II Operation Manual

Replacing the Epson 2200 Ribbon Cable

customer1 comment

KIOSK PARTS  

Setting up Your DTG Kiosk Checklist

customer

Download the DTG Quick Set Up Guide Also, try downloading the DTG Kiosk BASICS Manual Start to Finish List of Setting Up Your DTG Kiosk (1) Inspect carton for damages. (2) Open carton. (3) Remove top cardboard and set aside. DO ONT DISCARD ANY PACKING MATERIALS (4) Inspect to make...

VIDEO DTG Kiosk 1 Replacing the Cleaning Solution Bottle

customer

VIDEO DTG Kiosk 1 Print Head Alignment

customer

VIDEO DTG Kiosk 1 Putting a shirt on the Platen

customer

VIDEO DTG Kiosk 1 Using the Ink Valves

customer

Take a look at our newer direct to garment (DTG) models on our page down below. https://www.garmentprinterink.com/collections/dtg-printers/products/ricoh-ri2000-commercial-garment-printer https://www.garmentprinterink.com/collections/dtg-printers/products/ricoh-ri1000-commercial-garment-printer

How to Change Your Ink System: DTG Kiosk 1 Video Tutorial

customer

Check out this insightful video tutorial on changing the ink system for the DTG Kiosk 1 direct-to-garment printer. This crucial step ensures vibrant prints on various materials.

VIDEO DTG Kiosk 1 Standard Nozzle Check

customer

VIDEO DTG Kiosk 1 Plugging in your Cables

customer

VIDEO DTG Kiosk 1 Tape and Bracket

customer

VIDEO DTG Kiosk 1 Print head Alignment and Nozzle Check

customer